Cutting Method Of Cast Basalt Composite Pipe

Cast basalt composite pipe is an important engineering plastic, which has a wide range of uses. Large and medium-sized enterprises and individuals have varying degrees of demand for it. Generally, the cast basalt composite pipe purchased from the market is a whole piece, and its shape and size are somewhat different from those required. It often needs to be cut before it can be used. The following is a brief introduction to the method of coal bunker lining plate:

1. Semi automatic cutting machine cutting: the quality of the plate cut by the profiling cutting machine is good. Because the cutting die will be used in the cutting process, it is generally suitable for batch cutting of some regularly shaped parts.

2. Nc cutting machine cutting: nc cutting can effectively improve the efficiency and quality of plate cutting. It is generally used for parts with thick plate surface, high hardness and high requirements for cutting quality and accuracy, and its cost is relatively high.

3. Red cutting: generally, the plate with thickness less than 2mm can be cut with paper cutter or hook knife. The thin plate can also be cut with pull saw, electric saw, manual cutting machine, etc. The red cutting is flexible and convenient. It can be used for single piece or small batch cutting, but the cutting quality is poor and the dimensional error is large.

It is an important engineering plastic with a wide range of prospects. Large and medium-sized enterprises and individuals have varying degrees of demand for it. The coal bunker lining plate purchased from the market is generally a whole piece, and its shape and size are different from those required. It often needs to be cut before it can be used. The following is a brief introduction to the method of coal bunker lining plate:

1. Semi automatic cutting machine cutting: the quality of the plate cut by the profiling cutting machine is good. Because the cutting die will be used in the cutting process, it is generally suitable for batch cutting of some regularly shaped parts.

2. NC cutting machine cutting: nc cutting can effectively improve the efficiency and quality of plate cutting. It is generally used for parts with thick plate surface, high hardness and high requirements for cutting quality and accuracy. Its cost is relatively high.

3. Red cutting: generally, the plate with thickness less than 2mm can be cut with paper cutter or hook knife. The thin plate can also be cut with pull saw, electric saw, manual cutting machine, etc. The red cutting is flexible and convenient. It can be used for single piece or small batch cutting, but the cutting quality is poor and the dimensional error is large.